Adding ethernet to wifi adapters, will not connect to internet

@copz1998 & @gramps28 thanks for the assistance so far...much appreciated!

Here are the two adapters I’m trying to connect wirelessly to the G4AR gateway.  In the setups for both, they didn’t mention a “bridge mode” but I did set it to the option that was NOT “Access Point” mode.

The plan:  Put each one in a room where I have equipment that doesn’t have wifi capability.  I would run an ethernet cable from the equipment to the ethernet port on the side of the adapter.

Solved so far:  I can connect via wifi to both of these adapters to get them configured and ready to go.

Issue:  When I try to do the final step of connecting them via wifi to the G4AR gateway, the gateway refuses the connection request.  With the Netgear adapter (on the right), the gateway rejects the login (I’ve triple-checked that I’m entering the correct network password for the gateway).  With the BrosTrend adapter (on the left), I get a “successful connection” message in the UI, but when I refresh status it shows a broken connection to the gateway and internet.

My guess:  The G4AR for some reason is refusing to allow these adapters to connect to it.

I’m just about all out of ideas at this point.  If I can’t get this solved, my next step is to go to powerline ethernet adapters (which have worked for me in the past).

Hopefully someone can help me get these adapters connected to the gateway.

Thanks,

Drew