Support
SUPPORT New to T-Mobile? Switching is easy Set up your device Get a T-Mobile ID Sprint Migration Center All get started topics Ways to pay your bill All about your bill Line permissions Your T-Mobile ID Your PIN/Passcode All account resources topics T-Mobile Network In-flight texting and Wi-Fi Wi-Fi Calling International roaming Mobile Without Borders All network & roaming topics Find the right plan Neftlix on Us HotSpot plans Voicemail Use Mobile HotSpot All plans support topics Tutorials Troubleshooting Unlock your device Change your SIM T-Mobile eSIM All device assistance topics Account Hub I-Billing Home Office Internet Collaborate Line permissions All business support topics

Use these steps to support network settings on the T-Mobile 4G LTE HotSpot Z915.

 

 

 

APN & data settings

  1. Access the mobile hotspot admin page.
  2. Click the Settings tab.
  3. Click Network Settings.
  4. Under the APN heading, confirm the information entered is correct.
  5. To correct APN information, click Manual.
  6. Click Add New.
  7. Enter the following information:
    • Profile Name: T-Mobile
    • APN: fast.t-mobile.com
  8. Click Apply.

 

Manual network selection

The device detects and registers on wireless networks inside T-Mobile’s calling area, but roaming networks are usually restricted to T-Mobile SIM cards. You can manually select a network only in areas where T-Mobile does not own GSM spectrum.

 

  1. Access the mobile hotspot admin page.
  2. Click Disconnect.
  3. Click the Settings tab.

  4. Click Network Settings.
  5. Under the 'Network Selection' heading, click Manual.
  6. Click Search.
  7. Select the network to connect.
  8. Click Apply.

 

Switch 3G / 4G / LTE

  1. Access the mobile hotspot admin page.
  2. Click Disconnect.

  3. Click the Settings tab.

  4. Click Network Settings.
  5. Under the 'Network Selection' heading, click the drop down menu next to Automatic.
  6. Select one of the following:
    • UMTS Only
    • UMTS and LTE only
    • LTE Only
    • GSM/UMTS/LTE
  7. Click Apply.

 

Turn on / off data roaming

  1. Access the mobile hotspot admin page.
  2. Click Disconnect.

  3. Click the Settings tab.

  4. Click Network Settings.
  5. Under the 'WAN Connection Mode Settings' heading, check or uncheck Check here, to connect to the internet in roaming status to turn data roaming on/off.
  6. Click Apply.

Was this helpful?